keurig k duo plus auto brew instructions

#Keurig k duo plus auto brew instructions install#

Strong Brew increases your coffee strength and intensity for single cup and carafe brewing. Multi-Position Reservoir allows you to position the water reservoir to the right, left, or along the back of the brewer to optimize counter space. The brewer will heat, then automatically begin brewing.īrewer Auto Off automatically turns your brewer off 5 minutes after the last brew for energy savings.Īuto Brew programs the carafe to brew at a specific time, up to 24 hours in advance. Power on your brewer, add coffee, select your brew type, then select your brew size. No need to wait for the brewer to heat before selecting brew size. Smart Start heats then brews in one simple process. For a bolder coffee, press the STRONG button before pressing the brew button. Press the brew button to initiate brewing. Select CARAFE, then select your brew size. Exceeding this amount may cause overflow. NOTE: The maximum capacity for regular ground coffee is 15 tablespoons and 12 tablespoons for decaf. Reinsert the filter basket drawer completely and make sure the carafe is on the drip tray. Pull the filter basket drawer outward and add the desired amount of ground coffee (1 tablespoon of ground coffee per cup is recommended) to the gold tone mesh filter (or a 12 cup paper filter). We recommend using a Keurig ® Rinse Pod or running a cleansing brew immediately after brewing hot cocoa or other sweetened pods to keep the needles clean.įill the water reservoir to the MAX fill line. For a bolder coffee, press the STRONG button before pressing the brew button.īrewing is complete when the brew indicator light is no longer illuminated. High Altitude Brewing: While holding the brewer handle up, push down slowly on the K-Cup ® pod in the pod holder until the bottom of the K-Cup ® pod is punctured by the exit needle. Lower the handle completely to close the lid. Lift the pod holder door and place a K-Cup ® pod in the K-Cup ® pod holder. If using a travel mug, remove the drip tray and place the mug on the drip tray base. Press the POWER button to turn the brewer back on. NOTE: After 5 minutes the brewer will go into Auto Off mode. The one-time setup process is now complete and you are ready to brew! The brew is complete when the brew indicator light is no longer illuminated. Press the brew button to start the cleansing brew. Press the 8 button - the brew indicator light will blink. Press the CARAFE button - the 4 brew size buttons will blink. Do not fill filter basket with coffee grounds. Place the carafe on the drip tray and fill the water reservoir to the MAX fill line. NOTE: Between brew cycles, the brewer may take about a minute to reheat. The brew indicator light will pulse slowly on and off while the brewer is heating, and the light will turn solid once the brew begins. The initial heating process will take about 4 minutes. The cleansing brew will begin once the brewer is heated. The 4 brew size buttons will blink, press the 8 button - the brew indicator light will blink. NOTE: The clock must be set in order to use the Auto Brew functionality. Use the H/M buttons to set the clock, then press the blinking brew button to confirm the time. Refer to your Water Filter Starter Kit for instructions.įill the reservoir with fresh water to the MAX fill line, and replace water reservoir.

#Keurig k duo plus auto brew instructions install#

If you have a Keurig ® Water Filter, install it now. Place a large mug (12oz minimum) on the drip tray. positioned to the right, left, or Place a large mug (12oz along the back of the brewer to minimum) on the drip tray. The water reservoir can be Plug brewer into an outlet. For replacement parts, please visit Before You Brew